G45 Botanicabella Altered Notebook

I absolutely adore Graphic 45 paper! I recently found a few sheets from the Botanicabella Collection in my paper stash. I decided to create an altered notebook with the pages that I had.

Here is a picture of the completed notebook cover.

Supplies used in this project:

• (2)-12x12 sheets of Graphic 45's Botanicabella Collection Botanicabella #4500045
• (1)-12x12 sheet of Graphic 45's Botanicabella Collection Ode to a Butterfly #4500053
• Golden yellow cardstock 
• (1) 8.5x11" shimmery white cardstock
• Composition Notebook
• Adhesive for book making and paper ( I used Glue Arts High Tac and Perma Tac)
• 1/8" pop dots
• sharp scissors
• Wild Honey Tim Holtz Distress Ink
• Ink distressing tool
• Red gems in 2 sizes
• scotch tape
• metallic thread
• Heritage Corner punch from Fiskers
• Zots for Bling
• craft knife
• bone folder
• ruler
• other embellishments

 Directions-

-Using High Tac or other book making adhesive (Mod Podge for example), outline the edges of the cover of the Composition notebook. NOTE: Do not cover the black spine with adhesive.

-Center one (1) sheet of the Botanicabella 12x12 paper over the adhesive so that the edge abuts the black spine so that the red with gold design is facing up.


-Smooth paper down on the top of the notebook

-Trim the over hang along the width of the notebook leaving about 1" on paper past the edge of the cover.

-Take the bone folder and placing the notebook on it's cover run the bone folder around the edge of the cover. This creates a crease line-making the next step so much easier. 

-Fold the paper over the edge of the cover on one of the short sides and the long side. Place the ruler on an angle that connects the inner and outer corner of the folded paper. Using the craft knife cut along the edge of the ruler. Be careful not to cut through the cover. Remove extra paper and adhere the flaps to the cover. Repeat process on the other corner.

-Repeat this entire process for the back cover using the second piece of Botanicabella.

-Cut two pieces of golden yellow cardstock to fit within the cover of the notebook (if using a smaller or larger notebook than the standard composition notebook, cut the cardstock so that it rests 1/8" in from the long and short sides of the cover.) These inside pieces measure 9.5x6.75"

-Using the Wild Honey distress ink ink the golden yellow cardstock around the edges and adhere to the inside of the back cover.

-Create a pocket on the liner for the cover by placing the back side of Ode to a Butterfly on an angle across the liner. Using the corner covering process from above to adhere the pocket to the liner. Using scraps from the Botanicabella cardstock cut a strip of butterflies and adhere as a pocket edge and wrap around the back of the liner.

-Adhere liner to the inside of the front cover.

-Cut a piece of the the white shimmery cardstock to 3.5x5" Using the Heritage punch, cut all four corners of the cardstock

-Distress with Wild Honey ink and apply title (I used a "Dream" rub-on)

-Thread clock face embellishment (or embellishment of choice) on to the metallic thread. Using the cheater method attach the thread to the title block.

-From the paper scraps of the Botanicabella paper cut out seven butterflies. Create dementional butterflies by using pop dots to layer two of the butterflies together. Adhere two of the butterflies to the front cover around the title.

-Attach one to the center of the pocket liner on the inside cover. Attach the last butterfly (flat) to the top right corner of the cover liner.

Attach the red gems to the bottom of the front cover as pictured.

Steampunk Altered Art Shadow Coffin

Good Afternoon Everyone!

It's sunny and hot here in New Hampshire USA. Laundry is drying in the sun and I have finished another Steampunk themed project. I bought the coffin at Michael's and the paper from Stamping Memories in Belmont NH.

This item is available on ebay

Front of the outside-

 Inside the coffin-

The pattern paper is from the Graphic 45 Steampunk Debutante collection. I used some of Tim Holtz's Wild Honey distress ink around the edges of the paper.

I used denominational foam under the flowers in the left side of the coffin and the corset on the right side.

The charms are jewelry pieces in my collection of embellishments. The loop opens to add more charms or to change the assortment. I spray painted the gears using Krylon paints.

Thanks for stopping by my blog.

Steampunk Culture-Card #2 A Victorian Romance

Good Afternoon Everyone!

Here in New Hampshire it is sunny and 73 degrees. I can't believe it! So before I enjoy some sunlight I'm posting my newest card creation.

This card measures 4x5.5 inches. I used metallic bronze embossing powder to create the image of the dancers over the stamped music image. I used paper from Graphic 45's Steampunk Debutante collection and a jewelry finding from Jo-Ann's. The finding I chose represents a Claddagh ring. 

The following is quoted from Wikipedia in regards to a Claddagh ring:
"The Claddagh's distinctive design features two hands clasping a heart, and usually surmounted by a crown. The elements of this symbol are often said to correspond to the qualities of love (the heart), friendship (the hands), and loyalty (the crown). A "Fenian" Claddagh ring, without a crown, was later designed in Dublin. Claddagh rings, with or without the crown (most commonly with a crown), have come to denote pride in Irish heritage, while continuing to be symbols of love or marriage.
Claddagh rings may be used as friendship or relationship rings depending on the intention of wearer and, in the case of a gift, of the giver. The way that a Claddagh ring is worn on the hand is usually intended to convey the wearer's relationship status:

1. On the right hand with the heart facing outward, the wearer is single and may be looking for love.
2. On the right hand but turned inwards, the wearer is in a relationship, or their heart has been "captured".
3. On the left hand with the heart facing outward, the wearer is engaged.
4. On the left hand but turned inwards, the wearer is married^."

Steampunk Culture Card #1

Hey Everyone!

Lately I've been so into the Steampunk Culture. I love the Victorian dress mixed with Sci-fi mechanics. So I challenged myself to create a series of cards using a Steampunk theme. And what better way to do this than with Graphic 45's Steampunk Debutante Collection. 

The card below is my first in a series of Steampunk Cards. I Used a variety of techniques to create this card. This card measures 4x5.5 inches. I used Bazzill Cardstock to mount the Graphic 45 papers.

1st- I embossed the stamped image of the roses using VersaMark and Judi Kins' Metallic Bronze embossing powder

2nd- I used metal closures to accent the top left corner of the matted stamped image.

3rd- I used Copper thread to tie an antiqued metal bead to the base of the card. 

As always thanks for visiting my blog.